Category - Drawings and instructions

Setup Raw Creative with Arduino electronics

RE: DXF Scaling

Thank you for sharing. I ended up restarting my Fusion ...

By Kweku Amoo , 2 days ago
RE: DXF Scaling

I also pulled the dxf into fusion. I did not do any sc...

By Dan Howard , 2 days ago
DXF Scaling

Good Day,I’m importing the 6mm plates rack 2026.dxf fil...

By Kweku Amoo , 2 days ago
RE: Alternative plate method 2 CNC

Here is another low-cost option if you want to get star...

By Rawcnc , 3 days ago
Alternative plate method – CNC plasma + drill press

If you have access to a CNC plasma cutter, it is possib...

By Rawcnc , 3 days ago
RE: Machine support (table etc.)

Yes, this is an important point, especially for the lar...

By Rawcnc , 3 days ago
RE: Spindle considerations

Good question. I will try to answer generally, but I al...

By Rawcnc , 3 days ago
Machine support (table etc.)

Especially for the larger and heavier machines, even th...

By Steve Sandström , 3 days ago
Spindle considerations

I have a CNC previously that has a water-cooled spindle...

By Steve Sandström , 3 days ago