This forum is still new and may look a bit empty at the moment.
Please don’t hesitate to ask your questions. If you are building a Raw Creative 2.5, planning your build or wondering about parts, setup or assembly, feel free to start a topic.
I will do my best to answer questions and help as much as I can. As more builders join, the forum will grow into a useful place for tips, build discussions and shared experience.
Show your build
Show your Raw Creative 2.5 build
Post photos and videos of your machine
Forum feedback
Report missing documentation or errors
Suggest improvements to the build platform
-
Summer break – slower repliesReplies: 0
-
Calculator Feedback/suggestionReplies: 3
-
New topic creation is now enabledReplies: 0
Rack version build (1 viewing)
Discussion and questions about the rack and pinion version of the Raw Creative build, including frame setup, drive system, alignment, calibration and general build tips.
-
Rack version build statusReplies: 10
-
Issues putting it all togetherReplies: 0
-
Helical RackReplies: 5
-
Plates in the USA - alternative thicknessesReplies: 1
-
motor coversReplies: 1
-
Ball screw build
Discussion and questions about the ball screw version of the Raw Creative build, including frame setup, ball screw installation, alignment, motor setup, calibration and general build tips.
BOM and sourcing (1 viewing)
BOM updates and alternative suppliers
Share parts that worked well for your build
-
Material questionsReplies: 2
-
Rack and Pinion PlatesReplies: 1
-
-
Protective cover between platesReplies: 1
-
Square Tube for X-AxisReplies: 2
-
Build Tips & Tricks
Practical tips, smart methods and small workshop tricks for building the Raw Creative 2.5. Share useful ideas, jigs, templates, low-cost solutions, assembly tips, alignment methods and other things that can make the build easier, cheaper or more accurate.